Health & Safety

Painting Health Issues

It is truly wise to keep your health and safety in mind when starting any painting project. The latex or water born products are much preferred, as generally they don’t tend to give of the harsh fumes that the oil products do. However that is not to say that there is no need for concern.

Holtz Cabinets in Daytona Beach

Fine Finisher Health Concerns

Being stuck in a room all day painting without ventilation is not a good idea. Being able to open windows & leave the room for occasional breaks is helpful. Consider the degree of exposure & the time of exposure. If you paint 1 door casing in a large room in a big house, with widows open, the intensity of the fumes in the air should be minor. But if you paint all walls & the ceilings in a room having windows & doors closed this is probably not a healthy situations

Fumes from these ammonia-containing paints may more irritable than from the non-ammonia containing paints latex paints, yet not usually as hazardous as the oil based. Depending on your particular exposure situation, using these ammonia-containing products may or may not be a concern.

Mildew-Inhibitors: For mildew prone areas latex bathroom paint may be the best choice. Mildew inhibitive additives are available, but can be a hazard to use. Exterior paints are not usually recommended for interior use. The bathroom type paint contains a more appropriate mildew inhibitors for interior use and dose not require that you handle small containers of very toxic chemical additives.

To be on the safe side do not use any mildew inhibitive paints inside where it is not necessary. Stick with the latex bathroom paint. Use a bit more caution while working with mildew inhibitive paint, most mildew-chides are considered toxic.

Latex Allergies: In recent years we have been hearing about the increasing latex allergy concern. There are numerous products about that may contain some of the latex allergens, however according to the American Academy Of Allergy, Asthma & Immunology (AAAI); latex paints are not usually a problem, because they do not contain natural latex. For more information on latex allergies check-out the AAAI websitehttp://www.aaaai.org/

 


Controlling Dust

Sanding primed surfaces, previously painted surfaces, Spackle and other fillers produces dust. Fine partials enter the air, into your lungs and can easily permeate into nearby rooms. Doing a light sanding between finish coats just to knock of any occasional pieces of grit, probably will not cause a dust problem Sanding on latex dose not usually create as much of a dust problem as the oil base paints. But when thoroughly sanding oil base primer or filler especially joint compound, always take some measures to keep the amount of dust exposure to a minimum.

Keep some disposable dust mask on hand, they’re inexpensive and available at most any place that sells paint. Where a hat with a visor .You may also want to use goggles if you have much sanding to do. Close doors to adjoining rooms & hallways, to prevent permeation. If you are working in an area that has an entry to another room but there are no doors to close, you may be able to hang a sheet of plastic over the entry.

A shop vacuum with a fine particle filter is a great asset; use it to vacuum off sanded surfaces & then the floor. You may be able to use your household vacuum cleaner, but if you have accumulated a lot of dust, a household vacuum may not be built for this kind of use.

Changing the bag or filter of a household vacuum immediately after heavy-duty use is recommended.Caution, do not vacuum where there may be an accumulation of lead dust, unless you have a special vacuum designed for such use. (Please see lead section

Wet Sanding can be another option to minimize spreading dust.

Until recently wet sanding has not been particularly popular with most house painters, it is becoming a more common method of sanding due to lead paint concerns. Wet sanding paper is designed so that it can be kept wet by frequently dipping in water, a spray bottle may also be used to wet surfaces.

A pasty film may accumulate on work surfaces while wet sanding, this film can be washed off with a sponge before painting.


Lead

In recent years one of the major health safety issues has been concern over exposure to lead based and lead containing paint. Paints containing lead were outlawed to sell to the general public in 1978. The older your home prior to 1979, the more likely you are to have lead in your paint.

Just because a house was built before 1978 does not necessarily mean it was painted with lead containing products, many products were available before 1978 that did not contain lead. Latex paint seldom contained lead.

Of course where exactly the lead paint is would determine weather or not there is much risk of lead exposure. Doors and windows should usually be the first place to test for lead. Children and pets will sometimes chew or windowsills, shelves, handrails or other protruding objects.

Friction on window sash wears paint thus producing fine dust, the same problem occurs when doors rub against the jambs. Also these objects are frequently handled daily. Consider areas that surface-wear like stair treads and floors. Areas prone to pealing (windows & sills on interior) are also a high concern. It is quite likely that most of your home has been repainted since 1978 .If so walls and ceiling that are in sound condition, probably do not pose much of a threat

 

The EPA or Environmental Protection Agency has extended information on lead paint issues and provide several excellent manuals available online in PDF or by mail. Check out there OPPT Lead Page http://www.epa.gov/opptintr/lead/

 

http://www.osha.gov/dte/outreach/index.html


If you’re looking for a Professional House Painter or Professional House Painting Contractor in the Port Orange or Daytona Beach FL area, look no further. Licensed and Insured: Florida State, LLC # L07000061421 Contact Jeffrey Whitmer by email jwhitmer@jjwpainting.com or phone (386) 214-5329